Quick Start - ST STM32MP135F-DK User Manual

6

Quick start

This chapter describes how to start a development quickly using the STM32MP135F-DK.
Before installing and using the product, accept the evaluation product license agreement from the
epla webpage.
Before the first use, make sure that no damage occurred to the product during shipment and check that:
• All socketed components are firmly secured in their sockets
• Nothing is loose in the board plastic bag or in the box
The STM32MP135 Discovery kit is a low-cost and easy-to-use development kit to quickly evaluate and start a
development with an STM32MP135 microprocessor in a TFBGA320 package.
To start using the STM32MP135F-DK, follow the steps below:
1. Check the boot mode switch positions on the board, as shown in
2. For a correct identification among the host PC device interfaces, before connecting the board, install the
USB driver available on the
3. To power the board, connect its USB Type-C
cable. As a result, the green LED LD1 (5 V PWR LED) and the blue LED LD3 light up, and the LED LD5
(ST-LINK LED) blinks.
4. The software demonstration and the several software examples that allow the user to use the Discovery kit
features are available at the
5. Develop an application using the available examples.
UM2993 - Rev 2
www.st.com website.
®
connector CN12 to a 5 V / 3 A USB Type-C
www.st.com/stm32mp1 webpage.
www.st.com/
Table 5.
®
charger with its
UM2993
Quick start
page 7/42