Safety Recommendations; Targeted Audience; Handling The Board; Battery - ST STM32MP135F-DK User Manual

5

Safety recommendations

5.1

Targeted audience

This product targets users with at least basic electronics or embedded software development knowledge like
engineers, technicians, or students.
This board is not a toy and is not suited for use by children.
5.2

Handling the board

This product contains a bare printed circuit board. As for all products of this type, the user must be careful about
the following points:
• The connection pins on the board might be sharp. Handle the board carefully to avoid getting hurt.
• This board contains static-sensitive devices. To avoid damaging it, handle the board in an ESD-proof
environment.
• While powered, do not to touch the electric connections on the board with fingers or anything conductive.
The board operates at voltage levels that are not dangerous, but some components might be damaged
when shorted.
• Do not put any liquid on the board; avoid operating it close to water or at high humidity level.
• Do not operate the board if it is dirty or dusty.
5.3

Battery

This product does not include a battery.
5.4

Laser

This product does not include a laser.
5.5

Power supply

This product is not delivered with a power supply.
The equipment must be powered by a power supply unit or an auxiliary equipment complying with the standard
EN 60950-1 (2006+A11/2009+A1/2010+A12/2011+A2/2013) / EN 62368-1 (2014+A11/2017), which must be
Safety Extra Low Voltage (SELV/ES1) with limited power capability (LPS/PS2).
UM2993 - Rev 2
UM2993
Safety recommendations
page 6/42