Quick Start; Getting Started; System Requirements - ST STM32 NUCLEO-F030R8 User Manual

Quick start

3 Quick start
The STM32 Nucleo board is a low-cost and easy-to-use development platform used to
quickly evaluate and start a development with an STM32 microcontroller in LQFP64
package.
Before installing and using the product, please accept the Evaluation Product License
Agreement from www.st.com/stm32nucleo.
For more information on the STM32 Nucleo boards and to access the demonstration
software, visit www.st.com/stm32nucleo.
3.1

Getting started

Follow the sequence below to configure the STM32 Nucleo board and launch the demo
software:
1. Check the jumper position on the board, JP1 off, JP5 (PWR) on U5V, JP6 on (IDD),
CN2 on (NUCLEO) selected.
2. For correct identification of all device interfaces from the host PC, install the Nucleo
USB driver available on www.st.com/stm32nucleo, prior to connecting the board
3. Connect the STM32 Nucleo board to a PC with a USB cable 'type A to mini-B' through
USB connector CN1 to power the board. The red LED LD3 (PWR) and LD1 (COM)
should light up. LD1 (COM) and green LED LD2 should blink.
4. Press button B1 (left button).
5. Observe how the blinking of the green LED LD2 changes according to clicks on button
B1.
6. The demo software and several software examples on how use the STM32 Nucleo
board features are available on www.st.com/stm32nucleo.
7. Develop your own application using the available examples.
3.2

System requirements

•
Windows PC (XP, Vista, 7, 8)
•
USB type A to Mini-B USB cable
8/55
All manuals and user guides at all-guides.com
DocID025833 Rev 4
UM1724