Chassis Hardware Information; Shipping Components - Fortinet FortiGate-7000F Series System Manual

FortiGate-7081F chassis
Each FIM and FPM and the SMMs have a Shelf Management Controller (SMC). These SMCs support IPMB
communication between the active SMM and the FIMs and FPMs and other chassis components for storing and sharing
sensor data that the SMM uses to control chassis cooling and power distribution. The FortiGate-7081F also includes
serial communications to allow console access from the SMM to all FIMs and FPMs.
The base backplane includes 1Gbps ethernet management connections between the SMMs and the FIMs. The base
backplane also supports 50Gbps Ethernet communication for management and heartbeat communication
between FIMs and FPMs.
FIM1 and FIM2 (IPMB addresses 0x82 and 0x84) are the FIM interface modules in slots 1 and 2. FIM data interfaces
connect the chassis to data networks. NP7 processors in the FIMs use session-aware load balancing (SLBC) to
distribute data sessions over the FIM Integrated Switch Fabric (ISF) to the 6x400Gbps connections over the fabric
backplane to the FPMs. Data communication between FIM1 and FIM2 occurs over a 1TB fabric connection.
The FIM 1Gbps MGMT1 and MGMT2 interfaces are used for Ethernet management access to chassis components. The
2x100Gbps M1 and M2 interfaces are used for HA heartbeat communication between chassis. The 2x25Gbps M3 and
M4 interfaces are used for remote logging or other management functions.
FPM3 to FPM8 (IPMB addresses 0x86 to 0x90) are the FPM processor modules in slots 3 to 8. These worker modules
process sessions distributed to them over the fabric backplane by the NP7 processors in the FIMs. FPMs include NP7
processors to offload sessions from the FPM CPU and CP9 processors that accelerate content processing. FPMs also
include data interfaces that increase the number of data interfaces supported by the FortiGate-7081F. Data sessions
received by the FPM data interfaces are sent over the fabric backplane to the FIM NP7 processors to be load balanced
back to the FPMs using SLBC.
The FPM 1Gbps MGMT interfaces are used for Ethernet management access to chassis components.

Chassis hardware information

This section introduces FortiGate-7081F hardware components and accessories including power requirements and
FIMs and FPMs that can be installed in the chassis.

Shipping components

The FortiGate-7081F chassis ships pre-assembled with the following components:
The 12U FortiGate-7081F chassis.
l
Two FIMs.
l
Up to six FPMs.
l
Two System Management Modules (SMMs) in the front of the chassis. (SMMs are not field replacable. If a SMM
l
fails, you must RMA the chassis. The chassis will continue to operate with one or no operating SMMs.)
Six 2500W AC Power Supply Units (PSUs), packaged separately that must be installed in the chassis.
l
Six SDG400 to C20 power cables.
l
Six power cable management clamps.
l
Three cooling fan trays installed in the back of the chassis.
l
One FIM blank panel installed in chassis slot 2.The FIM blank panel is part of the chassis package and should be
l
kept available to fill the empty FIM slot if the chassis is operating with one FIM.
Five FPM blank panels installed in chassis slots 4 to 8.The FPM blank panels are part of the chassis package and
l
should be kept available to fill empty FPM slots if the chassis is operating with less than six FPMs.
FortiGate-7081F 7.0.5 System Guide
Fortinet Technologies Inc.
14