Table of Contents
Advertisement
85DR / 85DRB
2-3 Memory Installation
How to tackle with the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your main board and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM in a
socket improperly will damage the memory module and socket.
• Make sure you have the right type of memory module for your mainboard.
2-3.1 To Install DDR SDRAM Module for this Series :
• This series only supports up to 2GB unbuffered DDR SDRAM, with 2 DDR
DIMM sockets on board. Do not insert other type of modules into these
sockets.
• DDR DIMM socket has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin socket with the notch matching the one in the
socket. Press the Module down in a gradual way until it surely reaches
the bottom and clicks straight up the two latches on the left and right of
the socket. If any one of the latches has not turned up completely, you
should unplug the module and press it down the socket a bit more firmly.
184-Pin DIMM Notch Key Definitions (2.5V)
DRAM Key Position
Voltage Key Position
2.5V
Module Latch
20
Advertisement
Table of Contents
