Table of Contents
Advertisement
Power Management/
Max Saving
User Define
Min Saving
Video Power Down
Mode
Hard Disk Power Down
Mode
Standby/Suspend
Time Out (Minute)
Throttle Slow Clock
FDC/LPT/COM Ports When FDC/LPT/COM is Monitor, any activity from
MIDI Ports This item allows you to configure MIDI Port.
This option allows you to select the type (or degree)
AMP
of power saving for Doze, Standby, and Suspend
modes.
This table describes each power management
mode. Default: User Define.
Maximum power savings. Only Available for SL CPUs.
Inactivity period is 1 minute in each mode.
Set each mode individually. Select time-out period in
the section for each mode stated below.
Minimum power savings. Inactivity period is 1 hour in
each mode (except the hard drive).
This option specifies the power conserving state that
the hard disk enters after the specified period of hard
drive inactivity has expired.
When enabled and after the set time of system
inactivity, the Hard Disk drive will be powered down
while all other devices remain active.
The option specifies the length of a period of Hard
disk drive inactivity. When this length of time
expires the system enters power conserving state
in the "Hard Disk Power Down Mode".
Please leave this field at default setting.
Ratio
one of the listed system peripheral devices or IRQs
wakes up the system.
The Choices: 300H(default); 330H.
69
Chapter 4 BIOS Setup
Advertisement
Table of Contents
