Setting The Types Of Card To Use; Adjusting The Feed Gate Depending On Card Thickness - Canon IX-R7000 Operation Manual

5
As time approaches for replacement of
the ink ribbon or transfer film, a
notification will display the remaining
quantity.
• In normal mode, if the ink ribbon and transfer film
remaining quantity drops below the settings value (%),
then the remaining quantity notification will appear at a
set frequency (approximately 4 seconds).
→See "Changing the Ink Ribbon and Transfer Film" on
page 13 for details about changing the ink ribbon or
transfer film.

The factory default setting for [Ribbon Notice(%)] and [Film Notice(%)] is [0].
Note

Setting the Types of Card to Use

 Adjusting the Feed Gate Depending on Card Thickness
Adjust the card case and the gate gap to match the fed cards.
1
Open the top cover, and remove the
card case.
• Hold the card case handle, and remove.
2
Open the card case, and remove the
cards from the card case.
• Pull the lock, and open the card case cover.
• Pull the card retainer, after removing the cards, return
the card retainer to its original position.
• Remove the cards, and close the card case cover.
43
Card Retainer