Table of Contents
Advertisement
4
Change the settings by using the /
keys, then press the SET key.
• Settings values that can be changed are shown below.
• If CARD1-3 is selected, then go to Step 5. If other
settings values are selected, then you have finished.
Settings Value
PVC (0.76 mm)
PET (0.76 mm)
PET-G (0.76 mm)
Composite PVC
PC (0.76 mm)
CARD1 (XX,+XX)
CARD2 (XX,+XX)
CARD3 (XX,+XX)
The factory default setting is [PVC (0.76 mm)].
Note
45
Perform secondary transfer using conditions corresponding to 0.76 mm
thickness standard PVC card.
Perform secondary transfer using conditions corresponding to 0.76 mm
thickness standard PET card.
Perform secondary transfer using conditions corresponding to 0.76 mm
thickness standard PET-G card.
Perform secondary transfer using conditions corresponding to 0.76 mm
thickness standard Composite PVC card.
Perform secondary transfer using conditions corresponding to 0.76 mm
thickness standard PC card.
Perform secondary transfer using conditions set for values set for CARD 1-
3. The left value is the transfer speed, and the right is the transfer
temperature. Selecting either of these settings will then transition to transfer
speed/transfer temperature settings.
→See Step 5
Card Type
Card Type
PVC (0.76mm)
PVC (0.76mm)
Card Type
Card Type
CARD3 (00/+00)
CARD3 (00/+00)
Details
Advertisement
Table of Contents
