Figure 3-4 Winding The Ribbon Wheel - QMS ColorScript 310 User Manual

Chapter 3 — Changing Printer Ribbons
NOTE:
overtighten the ribbon. The ribbon should drape smoothly between
the two rollers, sagging no more than 1 inch (2.5 cm) below
horizontal.
Rear
Spindle

Figure 3-4 Winding the Ribbon Wheel

NOTE:
the rest of this procedure and follow the instructions in "Printing in
Monochrome Mode" on Page 35.
4. Press downward gently on the printer cover until it
clicks into place.
The red front panel indicators should all turn off.
You will hear a whirring sound as the printer moves the dye
ribbon forward to the first dye panel.
If the front panel ribbon indicator glows red, open the top
cover and review this procedure. Be sure that the dye ribbon
and all gears are properly seated.
34
The paper may jam if the dye ribbon is too slack, but do not
If you are installing a continuous monochrome ribbon, skip
Ribbon Wheel
Cassette Handle
Front Spindle