AJAX FireProtect 2 Jeweller User Manual page 8

3. Add a hub compatible with the detector
settings and create at least one
4. Make sure that the hub is on and has Internet access via Ethernet, Wi-Fi,
and/or mobile network. You can do this in the Ajax app or by looking at the
LED indicator of the hub: it should light up white or green.
5. Make sure that the hub does not start updates and that it is disarmed by
checking the status in the Ajax app.
A PRO or a user with system setup rights
To connect to the hub, the detector should be within the coverage area of the
hub radio network. To operate via a
the detector to the hub and then to the range extender. You can do this in the
range extender settings in Ajax apps.
How to connect FireProtect 2 to a hub
1. Open the Ajax app
2. Select the hub if you have several of them or if you are using the
app .
3. Go to the Devices
4. Enter the name of the device.
5. Scan the QR code or enter the ID manually. QR code is located on the rear
part of the enclosure (under the mounting panel) and on the device
packaging. The device ID can be found below the QR code.
6. Select the virtual room
7. Click Add; the countdown will begin.
If the maximum number of devices is added to the hub, when you add the device,
you will get a noti cation about exceeding the device limit. The number of devices
that you can connect to the hub depends on the
virtual room
radio signal range extender
.
tab. Press Add Device.
and security group (if the
to your app. Set the required
.
can connect the device to the hub.
group mode
central unit model
, rst connect
Ajax PRO
is enabled).
.