AJAX FireProtect 2 Jeweller User Manual page 15

If no sound and LED indications occurred during the self-test, the detector may not be
used. Contact our
Testing at the place of installation
Ajax security system provides several tests to select the correct installation
place of devices. Jeweller Signal Strength Test is available for FireProtect 2.
The test determines the strength and stability of the signal at the intended
location of the device.
To run the test in the Ajax app:
1. Select the hub if you have several of them or if you are using the
app .
2. Go to the Devices
3. Select FireProtect 2 (Heat/Smoke/CO).
4. Go to the settings by clicking on the gear icon
5. Select Jeweller Signal Strength Test.
6. Perform the test following the tips in the app.
The test does not start immediately, but the waiting time does not exceed the duration of
one detector ping interval. The default value is 36 seconds. You can change the detector
ping interval in the Jeweller (or Jeweller/Fibra) menu in the hub settings.
Icons
The icons show some of the device states. You can view them in Ajax apps in
the Devices tab.
Icon
Jeweller signal strength between the detector and the hub or radio signal range
extender. The recommended value is two or three bars.
Technical Support .
menu.
.
Meaning
Ajax PRO