AJAX FireProtect 2 Jeweller User Manual page 22

If CO detected
Jeweller Signal Strength Test
Device Self-test
User Guide
Temporary Deactivation
Unpair Device
When this option is enabled, the
connected to the system are activated when the
detector registers a dangerous CO level.
Switches the detector to the Jeweller signal
strength test mode. The test helps determine
the optimal place for installing FireProtect 2.
The test shows the signal strength between the
detector and the hub or range extender via the
Jeweller wireless data transfer protocol.
The recommended value is two or three bars.
Learn more
Runs a detector self-test.
Learn more
Opens FireProtect 2 User Manual in the Ajax
app.
Allows to temporarily deactivate the device
without removing it from the system. Three
options are available:
No — the device operates in normal mode.
Lid only — detector's tamper triggering
noti cations are disabled.
Entirely — the detector does not execute
system commands, does not participate in
automation scenarios, and does not send
noti cations of alarms, malfunctions, and
other events to the CMS and system users.
In this case, the detector will continue to
operate autonomously and indicate alarms
using the built-in siren.
Learn more
Unpairs FireProtect 2 from the hub and deletes
its settings.
Ajax sirens