AJAX FireProtect 2 Jeweller User Manual page 20

Temporary Deactivation
Firmware
Device ID
Device No.
Settings
To change FireProtect 2 (Heat/Smoke/CO) settings in an Ajax app:
1. Open the Ajax app.
No — the CO level is normal.
Alarm — the detector has detected a
dangerous CO level.
If a dangerous CO level is detected by the
detector, the text eld will turn red.
Learn more
Shows the status of the device temporary
deactivation function:
No — the device operates in normal mode.
Lid only — detector's tamper triggering
noti cations are disabled.
Entirely — the detector does not execute
system commands, does not participate in
automation scenarios, and does not send
noti cations of alarms, malfunctions, and
other events to the CMS and system users.
In this case, the detector will continue to
operate autonomously and indicate alarms
using the built-in siren.
Learn more
FireProtect 2 rmware version.
ID (serial number) of FireProtect 2. Also
available on the detector's enclosure (under the
mounting panel) below the QR code and on the
packaging box.
The number of FireProtect 2 loop (zone). Events
are sent to the CMS with this number.