Table of Contents
Advertisement
□ yL, yH, set bit image vertical direction data byte (yL+yH*256).
[Notes] □ In standard mode, this command affects only when there are no data in print buffer area.
□ For grating bit image print, this command doesn't affect by print mode (character size, bold,
overlap, upside down print, underline, invert blank print etc.).
□ If the printable area width which set by GS L and GS W is narrower than the min width, the printer
only extends the problem line to the min width. The min width for the normal mode (m=0,48) and
the double height mode(m=2, 50) are one dot, for the double width mode(m=1,49) and the four
times mode(m=3,51) are two dots.
□ The data out of the print area be read, and discarded one by one.
□
position is multiple of 8. The continuthe
position as the grating bit image print, set by HT(horizontal table),
print position), ESC \ (set relative print position) and GS L(set left side spacing).
□ The set by ESC a (set justification) for the grating bit image is also effective.
□
command during macro definition, the printer finishes the macro definition, and begins to execute
this command. The definition of this command
□
bit image data. Set the dot which will be printed as 1, the dot which
printed as 0.
[For example] When xL+xH^ 256=64
GS w n
[Name]
Set bar code width
[Format]
ASCII
GS
Hex
1D
Decimal
29
[Range]
2<n<6
[Description] Set bar code horizontal size.
n set bar code width as follows:
n
Multi bar code unit width(mm)
2
0.250
3
0.375
4
0.560
5
0.625
0.750
6
□
Multi bar code as follows:
PRINTEX P250 User Manual
w
n
77
n
119
n
Binary bar code
Narrow width(mm)
0.250
0.375
0.500
0.625
0.750
If the continued character
edcharacter print
ESC$(setabsolute
Receive this
shouldbe cleared.
d specifies
won't be
Wide width(mm)
0.625
1.000
1.250
1.625
2.000
60
Advertisement
Table of Contents
