Table of Contents
Advertisement
Decimal
27
[Description]
Set the line spacing to 3.75mm
[Note]
Line spacing set independently
[Reference]
ESC 3
ESC 3 n
[Name]
Set line spacing
[Format]
ASCII
ESC
Hex
1B
Decimal
27
[Range]
0 Sn S255
[Description]
Set line spacing [n *0.125mm].
[Notes]
□
Sets line spacing independently in stable mode
□
In stable mode, uses vertical unit
[Default]
[Reference]
(y). n = 30
ESC 2
ESC ? n
[Name]
Cancel user-defined characters ASCII
[Format]
Hex
Decimal
[Range]
32 Sn S126
[Description]
Cancel user-defined characters.
[Notes]
□
This command stops the type which defined for character code, character code set by n
. After canceling the user-defined character, prints with inner character relative mode.
□ Select character type by ESC !, this command defect the type which defined the pointed
code.
□ If one of the user-defined characters do not define, then the printer ignore this
command.
[Reference]
ESC
& , ESC %
ESC @ ____________________________________________________________________________________
[Name]
Initialize printer
[Format]
ASCII ESC
Hex 1B
Decimal 27
[Description]
Clears the data
in
effect when the power was turned
□ The set of DIP swith and Memory Switch won't check.
[Notes]
□ The data in receiving buffer area won't be cleared.
□ Macro definition won't be cleared.
ESC a n _________________________________________________________________________________
[Name]
Select alignment mode
PRINTEX P250 User Manual
50
(30 □ 0.125mm).
in stable mode and
3
n
33
n
51
n
ESC
1B
3F
27
63
@
40
64
the print buffer and resets the printer modes to the modes that were in
on.
page mode.
?
n
n
n
36
Advertisement
Table of Contents
