Table of Contents
Advertisement
2)
When ASB is used, the host is preferably in the wait state for data acception (ReverseIdle Mode).When this
state is not available, the host shall enter the Reverse Mode to always monitor the presence of data.
3)
When ASB is used, preference shall be given to the ASB status for transmission over the other status
signals. Once one ASB conditions changed, all ready to send ASB conditions from last time that need to send
together, then sending the latest ASB conditions.
2.1.3
Ethernet Interface
2.1.3. Ilnterface Specifications
Ethernet Type: Standard Ethernet (10M)
TCP/IP agreement: ETHERNET, ARP, IP, TCMP, IGMP, UDP, TCP, HTTP, DHCP;
Connector Type:
RJ45 (as table)
2.1.3.2 Interface connection
1. Default IP address "192.168.1.6", IP port "9100", checked by self-test list;
2. Link the printer to LAN, open IE and input the IP address of the printer, default "192.168.1.6", Carriage return to
log in. After modifying the related information, then "Reset";
3. If printing by Windows driver, install PRINTEX P250 driver. After installing driver, find installed PRINTEX P250
driver in "printer and fax". Choose attribute, then "Port"-"Add port"-choose "Standard TCP/IP Port", operate
according its prompt.
4. Change driver to this port, test through printing test page.
Notes:
1. Default IP port 9100, normal condition that needn't change;
2. Add "Standard TCP/IP Port", when choosing "Device type", to choose "Standard".
2.1.3.3 Interface Pin Signal Definition
Pin NO.
1
2
3
4
5
6
7
8
2.1.4
USB Interface
2.1.4.1 Interface Specifications
Connector Type: Type B female interfaceB
Communication Agreement: USB2.0
2.1.4.1Interface connection
PRINTEX P250 User Manual
Signal Name
TX+
TX-
RX+
N/C
N/C
RX-
N/C
N/C
Signal Source
Tranceive Data+ (Send signa+)
Tranceive Data+-(Send signa-)
Receive Data+ (Receive signal+)
Not connected(Blank)
Not connected(Blank)
Receive Data-(Receive signal-)
Not connected(Blank)
Not connected(Blank)
11
Advertisement
Table of Contents
