Gs H N - PRINTEX P250 Manual

□ If the printable width which set by GS L and GS W is less than the asked width by GS to send the data, then
executes the following continued operation for the problem lines [the print can not over the max printable area].
© The width of the printable area which extends to the right and holds the data capacity.
© If the step © can'provided enough width for data, then narrows the left blank to hold the data.
Each data in stable mode (m=0, 48) and double height mode (m=2,50), the printer prints one dot;
Each data under the double width mode (m=1, 48) and four double mode (m=3, 51), the printer prints two dots.
[Reference] GS *
GS :
Start/end macro definition ASCIIGS
[Name]
Hex 1D
[Format]
Decimal 29
Start/end macro definition
□
[Description]
When receiving this command in stable operation, starts macro definition. When receiving this
[Notes]
command during macro definition, finishes the macro definition.
□
During macro definition, when receiving GS
definition.
□
When turns the power on, undefined macro.
□
ESC @ does not clear the content of macro definition. So, ESC @ could be contained in macro definition.
□ If the printer receives GS :, then receiving GS promptly,the printer stops on undefined macro definition.
□ The content of macro definition reaches to 2048 bytes. If the content of macro definition overs 2048 bytes, so it can
not store the over part of data.
[Reference]
л
GS

GS H n

[Name]
Select print position of HRI characters ASCII
[Format]
Hex 1D
Decimal 29
0 < n <3; 48 < n <51
[Range]
Print bar code, select print position of HRI characters. n select print position, as following table:
[Description]
n
0, 48 Not print
1, 49 Above bar code
2, 50 Below bar code
3, 51 Above and below bar code
Note: Printing HRI character position does not set according to the standard
PRINTEX P250 User Manual
:
3A
58
л
, the printer stops macro definition and clears macro
GS H
48 n
72 n
Print position
n
50