Gswnlnh - PRINTEX P250 Manual

□
Only partial cut; not full cut.
[The particularize for ©]
□ When n £0, the printer feeds paper to (cut paper position+[n*0.125™{0.0049 inch}] and
cut paper.

GSWnLnH ____________________________________________________________________________

[Name] Set pirnt area width
[Format] ASCII GS
Hex 1D
Decimal 29
[Range] 0 S nL S255
0 S nH S255
[Description] Set print area width by nL and nH.
□ Set print area width as [(nL + nH*256) *0.125mm].
The left side blank The width of printable width [Notes]
This command only affects when processing the line origin.
□ If input this command in page mode, The printer executes inner sign operation.
□ This command does not affect printing in page mode.
□ If set value overs the printable area, uses the max vaule of printable value.
□ The set priority of GS W is higher than GS L. If [Left blank+printable area width] overs the
printable area, the printer uses [printable area width- left blank]. However, do not use the set
which sets by GS W, reserve the set which sets by GS W.
□ If the printable area width set which is smaller than one character width, when printing character
data, execute the following steps:
® The printable area width extends to right to meet one character.
© If printable area width couldn't be extended fully, decrease left page to meet one character.
© If printable area w idti couldn't be extended fully, decrease right spacing.
□ If printable area width is smaller than one vertical line, when printing non-character data (for
example, bit image, the user-defined bit image ), only process the problem lines as follows:
® Extend printable area width to right and meet one vertical line of bit image in the printable area.
© If printable area width couldn't be extended fully, decrease left page to meet one vertical
PRINTEX P250 User Manual
W nL nH
57 nL nH
87 nL nH
Printable area
□
Printable area
T | Extends to right The printable area width
set by nL and nH
,
53