PRINTEX P250 Manual page 38

□
x specifies the number of dots in the horizontal direction.
[Particularize]^ Characters code can be defined: ASCII from <20>H to <7E>H (95 characters).
□ The continued characters code of several characters can be undefined. When only need one
character, so c1 = c2„
□
d is the dot data of characters. Dot mode is from the left in horizontal direction. The right
left dots are blank.
□
Define the data of user-defined character is (y*x) bytes.
□
Set the relevant of printing dot is 1 or 0 which is the relevant of do not printing the dots.
□ Define the different user-defined character mode for each character type by this
command. Set the character type by ESC ! or ESC M .
□ User-defined character and download bit image can not define at the same time. When
executing this command, download bit image will be cleared.
□
Under the following situations, user-defined characters will be cleared:
© E xecute ESC @.
© Execute GS *.
© Execute ESC ?.
@ The priiter reset or turn tie power off
□ When the user-defined characters defines in character typeB (9 □ 17), only effect to the
highest valuable bit of the third byte in the vertical direction data.
[Default] Inner character font
[Reference] ESC %, ESC ?
[For example]
□
When setting the character type A (12 *24).
PRINTEX P250 User Manual