Gs I N - PRINTEX P250 Manual

position.
□ HRI (Human Readable Interpretation) indicates the barcode corresponding characters.
□ Print HRI character which set by GS F.
[Note]
[Default] n = 0
[Reference] GS f, GS k

GS I n _____________________________________________________________________________

[Name] Transmit printer ID
[Format] ASCII GS
Hex 1D
Decimal 29
[Range] 1<n<3, 49<n<51
[Description] Transmit printer ID.
□ n indicates the type of printer ID.
n Printer ID type
1, 49 Printer type ID
2, 50 Type ID
3, 51
Firmware version
ID
[Type ID]
Off/o
Bit
n
0 OFF
ON
1 OFF
ON
2 -
3 -
4 -
5
-
-
6
7 -
[Particularize] □ n serial interface mode, controls by selecting DTR/DSR, be sure that the host have
ready to receive data(DSR signal is SPACE), The printer only transmits one byte. If the host
have not ready to receive data (DSR signal is MARK), the printer will be waited, until the printer
have ready to.
□ In serial interface mode, controls by selecting XON/XOFF, the printer only transmits one
byte, but not sure that the conditions of DSR signal.
□ When spreading the data in the receiving buffer area, transmits printer ID. After receiving this
command, could be waited a period of transmitting conditions, it decided
PRINTEX P250 User Manual
I n
49 n
73 n
ID
Model: PRINTEX P250, Hex: 21H
Below table
43H
Decim
Hex Function
al
Not support double byte character
00 0
code.
01 1
Support double byte character type.
00 0 Uninstall auto cutter.
Install auto cutter.
02 2
Undefined.
- -
- - Not used.
- - Not used.
Undefined.
- -
- - Undefined.
- Not used.
51