Esc C 3 N; Esc C 4 N - PRINTEX P250 Manual

vertical motor unit.
□ This command set the print position from present position to [(nL + nH *256) *0.125 mm]o
□ Any set over printable area which will be ignored.
[Notes]
□ Spacing N points the right: nL + nH □ 256 = N
N point the left:
Spacing
nH □ 256 = 65536 - N
□ In stable mode, uses horizontal motor unit.
[Reference] ESC $

ESC c 3 n ______________________________________________________________________________

[Name] Select paper sensors to output paper-end signals
[Format] ASCII ESC
Hex 1B
Decimal 27
[Range] 0 < n <255
[Description] Select paper sensors to output paper-end signals. □ Uses each parameter n as
follows:
Bit Off/On
Off
0
1 Off
On
Off
2
3 Off
On
4-7 -
□ Select several sensors and input signal. In this case, if any one of sensors detect paper
[Notes]
out, it will output paper out signal.
□ This command only effects to parallel interface, in serial interface mode, this command will be
ignored.
[Default] n = 0

ESC c 4 n ______________________________________________________________________________

[Name] Select paper sensors to stop printing
[Format] ASCII ESC
Hex 1B
Decimal 27
[Range] 0 <n <255
[Description] Selects the paper sensor to stop printing when paper end detected:
PRINTEX P250 User Manual
(negative direction ), uses 65536 complement code. nL +
c 3 n
63 33 n
99 51 n
Hex Decimal Function
- - Undefined.
Roll paper near-end sensor
00 0
disable.
Roll paper near-end sensor
02 2
enable.
- - Undefined.
Roll paper end sensor
00 0
disable.
Roll paer end sensor
08 8
enable.
- - Undefind.
c 4 n
63 34 n
99 52 n
40