Table of Contents
Advertisement
Length unit. 1 inch=25.4mm.
(9)
MSB
Most Significant Bit
(10)
LSB
Least Significant Bit
(11)
Baseline
The standard position of the character data what stocked in the print buffer area. The following indicates the general
characters position under the standard mode and page mode:
5.3 Detailed
Rotate the characters under the standard mode: (only when selecting the font A)
HEX
09
Decimal
9
[Description] Moves the print position to the next horizontal tab position.
[Particularize] • If didn't set the next horizontal tab position, then this command will be ignored.
• If the next horizontal tab position is out of the print area, then moving the print position to "print area width+1.
• Set horizontal position through ESC D command.
• Print position set on "print area width+1"and receive this command, the printer moves
ahead when buffer full, and execute the horizontal tab position at the starting of the next line.
[Reference] ESC D
LF
[Name]
Print and
line feed
[Format] ASCII
LF
HEX
0A
Decimal
10
[Description] Prints the
data in the
Moves the print position to the next horizontal tab position.
[Note]
This command set
PRINTEX P250 User Manual
*1 When selecting character font A, the width is 21 dots
printbuffer and feeds one
line, based
the printposition to thestarting of the
When selecting character B,
the width is 16 dots.
Explanation of Commands
HT
[Name]
Horizontal tab
[Format]
ASCII
on the current line spacing.
line.
HT
26
Advertisement
Table of Contents
