Camera; Installer Menu - Bosch AUTODOME 7100i User Manual

22 en | Configuration
Click Set to apply the changes.
4.4

Camera

4.4.1

Installer Menu

Application variant
Select one of the options from the dropdown list for each stream.
This functionality has no effect on video processed by 3rd party apps.
There are two application variants:
–
–
The blurring variant is useful when privacy is an issue, but determining the presence of motion
is still required.
Notice!
i
Select the application variant before making other changes.
The device restarts when you switch application variants. Restarting the device resets the
configuration options to factory defaults.
Sensor mode
The sensor mode specifies the base resolution and frame rates for the image quality settings.
Fast moving scenes use more frame rates (50 fps or 60 fps) for better image quality than slow
moving scenes. Adjust this setting as necessary.
This higher resolution (HD 1080p) gives maximum detail in these scenes, but can result in
motion artifacts for fast-moving objects because of the lower frame rates.
Some types of light can show flickering in the image when the frame rate is not synchronized
with the mains power frequency. To avoid this, the sensor mode frame rate should be in line
with the power frequency:
–
–
–
Camera LED
Select the Enabled or Disabled radio buttons to switch the Camera LED on or off.
Select Auto disable to let the device determine when the LED should be switched off.
The camera LED activates when powering on the device for the first time. The LED deactivates
automatically after 5 min.
Reboot device
Click the Reboot button to reboot the camera. There is a ten (10) second pause before the
dome starts its homing phase. During the homing phase, the camera pans left and right and
tilts up and down. It also adjusts the lens focus. The entire homing phase lasts approximately
40 seconds.
System controller settings
Click the Restore button to restore some of the cameras settings to their original defaults.
Note: This operation does not affect any PTZ settings, such as Pre-positions, IVA profiles,
Tours A and B, among others.
Restore settings
Click Restore to restore all settings, except network settings, to their defaults.
Note: Clicking this button also clears the service-level password. Operators must reset the
password before doing anything else.
2022-12 | V01 | DOC
AUTODOME 7100i (IR)
AUTODOME 7100i (IR) - BLURRING
50Hz: 25 or 50 fps
60Hz: 30 or 60 fps
AUTODOME 7100i IR 8MP model: 25 or 30 fps
User Manual
AUTODOME 7100i
Bosch Security Systems B.V.