Table of Contents
Advertisement
16
en | Configuring the camera before installation
5
Configuring the camera before installation
Notice!
i
Risk of damage to the camera
Do not change the camera orientation while the camera is still in the box. The camera head
must be free to rotate.
Notice!
Risk of damage to the camera
i
When you are configuring the camera in its packaging and you plan to install it on a pipe
mount, you must use a complete Bosch pipe mount (NDA-7100-PIPE or NDA-7100-PIPEF) to
supply power to the camera. It is the only way to make sure the board within the pipe mount
is installed in the correct way.
Notice!
i
Risk of permanent damage to the camera
The interface board connects only one way to the camera. Make sure that when you install it
in the mount (arm or pipe mount), you install it the correct way.
1.
2.
3.
4.
5.
6.
2023-02 | V01 |
Connect Ethernet with POE or Ethernet without POE and power wires to a NDA-7100-
PIPE or NDA-7100-PIPEF BOSCH Pipe Mount. For wiring requirements, refer to the
Connection chapter.
Connect the Pipe mount to the camera. Refer to Installing a pipe mount.
Supply power to the camera and connect the camera to the computer. Refer to
Connection chapter.
Configure the camera. Refer to the separate User Manual for details.
Disconnect the wires/ cables from the connectors in the base of the camera.
Disconnect the Pipe mount from the base of the camera.
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
