Bosch AUTODOME 7100i User Manual page 70

70 en | Status codes
Status
Code
6
7
8
9
2022-12 | V01 | DOC
Description
When operating using redundant
power sources, or when using
only a 24 VAC/36 VDC power
source, the camera is detecting
insufficient voltage being
provided by the external 24
VAC/36 VDC power source.
Camera may be operating in an
environment where ambient
temperature is below the
specification of the camera.
Camera may be operating in an
environment where ambient
temperature is above
specification of the camera.
Camera has been subjected to
high shock. Mechanical damage
to the camera may exist.
User Manual
Recommended action
(to be completed by a qualified Service
Technician)
3. If using the IEEE 802.3bt, Type 4 (95W)
High PoE Midspan, verify that both LEDs are
green. If not, refer to the "Troubleshooting"
section of the installation manual of the
midspan.
1. Verify that the 24 VAC/36 VDC power
source can provide at least 4.0 A to the
camera.
2. Verify that the wire gage of the power
cable is sufficient for the distance between
the power source and the camera and that
the voltage getting to the user cable of the
camera is between 21 VAC and 30 VAC.
1. Verify that the ambient temperature is not
below -40 °C (-40 °F).
2. Review the information about temperature
located in Logging diagnostics.
Note: Motorized zoom and focus functions of
the visible camera lens will be disabled until
the camera operates within the specified
temperature range.
1. Verify that the ambient temperature is not
above +50 °C (+122 °F).
2. Review the diagnostic log of the camera
(accessible from the Service menu) for errors
related to the operation of the internal fan.
3. Add the optional sunshield accessory to
reduce internal heating caused by sun
loading.
1. Verify the integrity of the mechanical parts
such as the arms and the pan body.
2. Verify the integrity/tightness of the
external fasteners. Tighten where necessary.
3. If obvious damage is present, stop using
the camera and contact the nearest Bosch
Security Systems Service Center.
4. If no damage is evident, power the camera
off and then on, and then evaluate
operational performance. If the camera does
not operate as expected, contact the nearest
Bosch Security Systems Service Center.
Bosch Security Systems B.V.
AUTODOME 7100i