AUTODOME IP starlight 7000i
13
Connection
13.1
Connecting the AUTODOME camera to the PC
1.
2.
3.
Notice!
i
The camera can also be connected directly to a PC using an Ethernet crossover cable with
RJ45 connectors (see option B below).
1
1
Figure 13.1: AUTODOME 7000 Series System Configuration
1
2
3
4
Notice!
i
You can also use the Bosch Video Client software application to configure the network
settings for an AUTODOME 7000 Series camera. Go to www.boschsecurity.com to download
the Configuration Manager software and Operating Manual.
13.2
Power Cable and Wire Distances Guides
Power
115/230 VAC
Copper Wire
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Bosch Security Systems
Install the camera according to the instructions in the appropriate Installation section of
this manual.
Connect an Ethernet cable from camera's RJ45 connector to a dedicated network switch
to bypass the Local Area Network (LAN).
Connect the dedicated network switch to the RJ45 connector on the PC (see option A
below).
2
3
2
AUTODOME 7000 Series
IP Connection
Network Switch
Computer
To comply with local codes.
2
4
4
Installation Manual
Connection | en
55
2021-03 | 1.2 |