Considerations For Mounting The Camera In Inverted Orientation - Bosch MIC IP starlight 7000i Installation Manual

22 en | Mounting
Route cables through the bottom of the SCA (to prevent water from running into the side or
top of the SCA along the cables).
Surface Mount
Figure 5.6: Direct surface mount – camera upright (MIC + base gasket)
Figure 5.7: Direct surface mount – camera inverted (MIC + base gasket + IP67 Weatherization/Connector
Kit)
5.4 Considerations for Mounting the Camera in Inverted
Orientation
To change the camera orientation to "Inverted," complete the following steps:
1.
2.
3.
4.
5.
6.
Note the position of the visor when the camera is installed in inverted orientation. The visor
will now be near the body of the camera.
2019-11 | 2.1 |
Remove the camera from the shipping box.
Apply power to the camera.
Access the web browser of the camera.
Access the page Configuration.
Navigate to Camera > Installer Menu > Orientation.
Select "Inverted."
The camera head will rotate automatically into inverted position (180°).
Installation Manual
MIC IP starlight 7000i
Bosch Security Systems