Example Of Subnet Routing; Table 8-1 Subnet Routing Example: Ip Address Assignments; Table 8-2 Subnet Routing Example: Ip Interface Assignments - Nortel Alteon OS 42C4911 Application Manual

Alteon OS Application Guide

Example of Subnet Routing

Prior to configuring, you must be connected to the switch Command Line Interface (CLI) as
the administrator.
N – For details about accessing and using any of the menu commands described in this
OTE
example, see the Alteon OS Command Reference.
1. Assign an IP address (or document the existing one) for each router and client worksta-
tion.
In the example topology in

Table 8-1 Subnet Routing Example: IP Address Assignments

Subnet
1
2
3
4
2. Assign an IP interface for each subnet attached to the switch.
Since there are four IP subnets connected to the switch, four IP interfaces are needed:

Table 8-2 Subnet Routing Example: IP Interface Assignments

Interface
IF 1
IF 2
IF 3
IF 4
148 Chapter 8: Basic IP Routing
Figure 8-2 on page
Devices
Primary and Secondary Default Routers 205.21.17.1 and 205.21.17.2
First Floor Client Workstations
Second Floor Client Workstations
Common Servers
Devices
Primary and Secondary Default Routers 205.21.17.3
First Floor Client Workstations
Second Floor Client Workstations
Common Servers
146, the following IP addresses are used:
IP Addresses
100.20.10.2-254
131.15.15.2-254
206.30.15.2-254
IP Interface Address
100.20.10.1
131.15.15.1
206.30.15.1
42C4911, January 2007