Installing The Chassis Feet - Nortel CallPilot Installation Manual

32 Chapter 3 Preinstallation requirements

Installing the chassis feet

Introduction
You can install feet on the bottom of the server. The feet stabilize the server
and will help prevent the server from accidentally falling over on its side.
To install the chassis feet
Step
1
2
Copyright © 2007, Nortel Networks
.
Action
Ensure that the server is laying on its side, supported to give the
server bottom four to five inches clearance above the work surface.
Attach the feet as shown in the preceding diagram.
Use four screws to attach each foot to the chassis. The holes in the
feet line up with only one set of holes in the chassis, as follows:
• front foot: The middle hole is towards the front of the chassis.
• back foot: The middle hole is towards the back of the chassis.
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Nortel Networks Confidential