Nortel CallPilot Installation Manual page 28

28 Chapter 3 Preinstallation requirements
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Action
Place the server on its side on your working surface.
Turn the two thumbscrews on the back of the server
counter-clockwise to loosen them.
Note 1: The thumbscrews are not removable.
Note 2: If a removable screw is present, remove it. This screw
secures the cover to the server during shipping.
Place your fingertips in the depression on the side cover, and then
as you apply pressure, pull the cover approximately 25 mm (1 in.)
away from the front of the server until it stops.
Use one hand to pull the top edge of the cover away from the server
to disengage the top row of tabs on the cover from the notches in
the chassis.
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Nortel Networks Confidential