Nortel CallPilot Installation Manual page 46

46 Chapter 4 Installing the server and connecting the peripheral devices
To connect the server to power
Step
1
Copyright © 2007, Nortel Networks
.
WARNING
Risk of personal injury and risk of hardware failure
You must connect the power outlets that are used by the CallPilot
server and its peripheral devices to the same single-point ground
reference as the one used by the switching system connected to
the CallPilot server.
If this requirement is not met, power transients can cause
personal injury, hardware failure, or both. For more information on
single-point grounding requirements, refer to the Installation and
Configuration Task List (NN44200-306).
Action
Plug the server's AC power cord into the server's rear panel.
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Nortel Networks Confidential