Nortel CallPilot Installation Manual page 47

2
To start the server
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
Plug the other end into a wall receptacle or power bar.
Action
Press the server power switch to start the server.
Observe the Power-On Self Test (POST) and initialization messages
on the monitor.
Let the mini-setup sequence run until you are prompted to log in
to the operating system.
Note: The system may perform multiple reboots. This is normal.
Ensure that the operating system logon window appears on the
monitor.
Note: If the logon window does not appear, refer to the
CallPilot Maintenance and Diagnostics guide for your server for
troubleshooting instructions.
Proceed with the CallPilot server and switch configuration guide for
your switch to connect and configure the server and switch.
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Connecting the server to power 47
—End—
—End—
Nortel Networks Confidential