Nortel CallPilot Installation Manual page 40

40 Chapter 4 Installing the server and connecting the peripheral devices
To connect the mouse, keyboard, and monitor to the server
Step
1
2
3
4
5
6
To connect the modem to the server
Step
1
2
3
4
5
6
Copyright © 2007, Nortel Networks
.
Action
Place the monitor, keyboard, and mouse in the same location as
the server.
Plug the keyboard and mouse into the appropriate PS/2 connectors
on the chassis rear panel. See the diagram on
Plug in the monitor connector. Tighten the screws on the connector.
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of
the switch.
Connect the power cord to the monitor, and plug the other end into
a wall receptacle or power bar.
Turn on the monitor.
Action
Ensure that the modem's AC power cord is not plugged in.
Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
Connect the 9-pin female connector to COM1 port at the rear of the
server. Tighten the connector screws.
Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
Connect the other end of the telephone cable to the RJ-11 jack in
the wall.
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
—End—
page 52.
Nortel Networks Confidential