Nortel CallPilot Installation Manual page 19

In the previous diagram, the telephony LAN (TLAN) provides IP connectivity
between the CS 1000 system and the i2004 Internet phonesets.
The connection between the Call Server and Media Gateway can be
point-to-point, or it can be through the LAN, if the system is installed in
a distributed data network.
For information about the CS 1000 system and i2004 Internet phoneset
bandwidth and network requirements, refer to the Communication Server
1000 Planning and Installation Guide.
Switch connectivity
For more details about how the 703t server and switch connection is
established, refer to the switch and server setup document for your switch:
•
•
LAN connectivity
The 703t server contains two Ethernet controllers on the motherboard that
provide the following:
•
•
See
interface connectors.
Network requirements
Appropriate networking equipment must be available for the ELAN subnet
and the optional Nortel server subnet if it is used.
The ELAN subnet (and the optional Nortel server subnet if used) must
be properly configured for correct CallPilot operation. To ensure correct
configuration, Nortel recommends that you consult a network specialist.
Copyright © 2007, Nortel Networks
.
Communication Server 1000 and CallPilot Server Configuration
(NN44200-312)
Meridian 1 and CallPilot Server Configuration (NN44200-302)
10/100Base-T Ethernet network connectivity to the ELAN subnet
(Meridian 1 and CS 1000 only)
For information about the ELAN subnet's purpose and requirements,
see the Planning and Engineering Guide (NN44200-200).
10/100/1000Base-T Ethernet connectivity to the Nortel server subnet
The Nortel server subnet is an optional connection that provides data
connectivity among desktop and Web messaging clients, administrative
PCs, and the CallPilot server.
"Rear panel diagram" (page 14)
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Network connectivity 19
to identify the location of network
Nortel Networks Confidential