6 Operation
6.1 Local Indicators
There are three (3) indicators located inside the rectifier enclosure (visible from the outside through a window located on the left side
of the rectifier). See Figure 6.1 for location and Table 6.1 for indicator functions.
NOTE!
AC voltage must be present at the rectifier input terminals for indicators to be functional.
Figure 6.1 Local Indicator Locations
Critical or Major
Alarm Indicator
Table 6.1 Local Indicators
Indicator
Status
Observation Alarm
Critical or Major Alarm
NOTE!
Load sharing is not in scope in the single rectifier system.
6.2 Narada Battery Local Indicators
Two (2) LED indicators are located on the bottom side of the battery. Refer to the battery manual for operating status of these.
6.3 Rectifier High Voltage Shutdown and Lockout Restart
Procedure
1.
Remove AC input power to the rectifier. Wait 30 seconds or more (until the LEDs on the rectifier extinguish). Re-apply AC
input power to the rectifier.
Status
Indicator
(Green)
Observation Alarm
(Red)
Indicator (Yellow)
Left Side Panel
Color
Normal State
Green
On
Yellow
Off
Red
Off
Proprietary and Confidential © 2022 Vertiv Group Corp.
Vertiv™ NetSure™ IPE Series Outdoor Rectifier Installation and User Manual
Fault State
Fault Cause
Off
No operation power supply.
On
There is an observation alarm.
On
There is a major or critical alarm.
61