Nortel 8300 User Manual page 65

7
8
VlanPortMembers dialog box
9
10
11
12
13
14
Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device Manager
Copyright © 2005-2007, Nortel Networks
.
This color is used by VLAN Manager to visually distinguish the
VLANs in a network.
Select the spanning tree group ID for the VLAN in the StgID field.
Click the ellipsis (...) in the PortMembers field.
The VlanPortMembers dialog box appears. See
dialog box" (page 65).
Click the ports to add to the VLAN. Ports that display in gray cannot
be added to the VLAN. (For example, you cannot select ports that
are not in the same STG as the new VLAN.)
Click Ok.
The VlanPortMembers dialog box closes and the port members
appear in the VLAN, Insert Basic dialog box.
When a protocol-based VLAN is created, all ports in the underlying
STG are automatically added as members, unless they are already
members of an existing protocol-based VLAN of the same type.
Select a protocol ID option button in the ProtocolId field.
To configure a non-standard protocol, see
protocol-based VLANs" (page
Click a level option button (0-7) in the QosLevel field.
Click Insert.
The VLAN, Insert Basic dialog box closes, and the protocol-based
VLAN is added to the Basic tab of the VLAN dialog box.
Do one of the following:
• If you are not configuring an IP address for the VLAN, click
Close.
The VLAN is configured and the VLAN dialog box closes.
• If you are configuring an IP address for the VLAN, see
"Configuring an IP address for a VLAN" (page
Nortel Ethernet Routing Switch 8300
NN46200-510 03.01 Standard
4.0 27 August 2007
"Configuring user-defined
66).
—End—
Creating a VLAN 65
"VlanPortMembers
62).