Mem-Id; Power Supply; Rs-232 Serial Port; Parallel Printer - DIGITIZE DDI-10E Installation And Operation Manual

DDI-10E INSTALLATION AND OPERATION MANUAL
When adding an account number to the SYSTEM 3505, you can assign it to any group
(i.e. 1 –8). The group fields are not used when receiving a Contact ID account. If an
existing 3x1, 4x2 etc. account switches to Contact ID, you only need to program the user
text messages for the new account numbers.
Note: You can use WIN3505 to simply renumber the account and use the same
message.
When a Contact ID account appears on the display, you will get the Contact ID info as
the first screen. Both zone specific and generic messages will work with the Contact ID.

1.3 MEM-ID

The Contact ID messages will be stored in a MEM-600 type IC labeled "Contact ID."
This EEPROM can be placed in the next available socket on the memory card. If you
have a system with a full card and the last MEM-600 is not used at this time, you may
remove the last MEM-600 and replace it with the "Contact ID" MEM-600. The MEM-600
that is removed can be installed on the next memory card purchased.
1.4 POWER SUPPLY AND BATTERY BACKUP
The DDI-10E will require an external 6-12 VDC power supply. The manufacturer of the
DDI-10E recommends .5AH x desired standby time. Digitize supplies a two-foot red and
black wire with a connector on one end for the DDI-10E and another to plug into the
AUX power output on the rear of the SYSTEM 3505. Since the DDI-10 is powered
through the System 3505, the DDI-10 will also use the battery backup that the System
3505 uses.

1.5 RS-232 SERIAL PORT

We will supply an RS-232 Configurator card with each DDI-10E. If the system you are
installing the DDI-10E into has no available port slots on the SYSTEM 3505 rear panel ,
then we can supply a quad serial expander card that plugs into the SYSTEM 3505 We
have issued two part numbers for the DDI-10E (one part number for DDI-10E with RS-
232 Configurator card and one with the Quad serial card). Unless otherwise noted, we
will deliver the RS-232 Configurator card on all in house orders. There is a price
differential based on the interface selected.

1.6 PARALLEL PRINTER

A parallel printer may be attached directly to the DDI-10E. This printer will operate
independently from the SYSTEM 3505.
700280-0001 Rev. B 5/11 Digitize, Inc.
1-3
Specifications Subject to Change Without Notice