Ddi-10E Setup; Win Exprecium Ii And Exprecium Iii; Win Exprecium Ii; The Exprecium Iii - DIGITIZE DDI-10E Installation And Operation Manual

5 DDI-10E SETUP

5.1 W E II E III
IN XPRECIUM AND XPRECIUM
The programs are used to configure the DDI-10 or update the DDI-10. The use of both
programs will be discussed here.
5.1.1 WinExprecium II
Use this program to Re-Configure the DDI-10 settings i.e.Handshake order, 3-2 instead
of 4-1 etc.
The WinExprecium.exe is simply copied to and run on your computer.
When the WinExprecium II program is run it will display a version number. The version
number displayed may not be the true version installed. To see the correct current
version installed in the DDI-10 use the Exprecium III program.

5.1.2 The Exprecium III

Use this program to update firmware. This program can also be used by your PC to
monitor incoming raw dialer data in place of your system 3505
Exprecium III is installed on your PC using the install setup.exe. When the Exprecium III
program is run it will display the full version number. Example shown here 2.0.1d
WARNING! If new firmware is installed the DDI-10 settings Must be Re-configured.
The "D" in V2.0.1 D is the indication of a Digitize version program.
700280-0001 Rev. B 5/11 Digitize, Inc.
5-1
Specifications Subject to Change Without Notice