Table of Contents
Advertisement
MOUNTING
4.2.4 Example 3: Brake with armature element - hub neck outside (e.g. 01...12-02-130-xxxx)
5
3
1.1
Figure 12:
Example 3: Brake with armature element - hub neck outside (e.g. 01...12-02-130-xxxx)
► The shaft of the motor and the mounting surface (3) must be constructed by way, that during mounting the
air gap X occurs automatically.
► If necessary, the air gap X can be adjusted with adjusting washers between armature element (6.3) and
shaft (5).
► Mount the feather key (4) into the shaft (5).
► Mount the magnet (1.1) with the socket head screws (2.1) to the mounting surface (3).
► Push the armature element (6.3) onto the motor shaft (5) with mounted feather key (4).
► Secure the armature element (6.3) with a shaft-end disc or retaining ring or with a threaded pin (8) axially
onto the motor shaft (5). Check the air gap X. Adjust it, if necessary.
Figure 13:
Mounting with threaded pin
4
6.3
2.1
8
X
Figure 14:
Mounting with shaft-end disc
31
Advertisement
Table of Contents
