Table of Contents
Advertisement
MOUNTING
4.2.2 Example 1: Brake without hub (e.g. 01...12-02-110xxxx)
3
1.1
2.1
Figure 10:
Example 1: Brake without hub (e.g. 01...12-02-110xxxx)
► The shaft of the motor and the mounting surface (3, 6) must be constructed by way, that during mounting
the air gap X occurs automatically.
► If necessary, the air gap X can be adjusted with adjusting washers between armature element (6.1) and
shaft.
► Mount the magnet (1.1) with the socket head screws (2.1) to the mounting surface (3).
► Place the armature element (6.1) against the screw mounting surface on the customer side (6) and tighten
the socket head screws (2.2) lightly with the Schnorr lock washers (4).
► Align the armature element and tighten the socket head screws.
► Mount the component (6).
► Secure the component (6) axially.
► Check the air gap X. Adjust it, if necessary.
2.2
6
1 .
6
4
X
29
Advertisement
Table of Contents
