Utility
other generators (set the clock source to "External) respectively. Finally, set the
output frequencies of all the generators as a same value to realize the
synchronization among multi-instruments.
13.3.3
Power On Settings
Set the configuration to be used when the instrument is powered on the next time to
Default,
Last
⚫
Default: Denote the factory default settings except some parameters (such as:
Language).
⚫
Last: Include all the system parameters and output configuration, except clock
source.
⚫
Output OFF: The last setting will be used and all output will be closed.
Press [Utility] >
When [P] key is pressed to restore the default settings, this setting will not be affected.
13.3.4
Intensity
Press [Utility] >
the backlight intensity of the screen.
The ranges from 1% to 100%.
13.3.5
System Information
Press [Utility] >
model, serial number, version number, etc.).
13.3.6
Unit
Press [Utility] >
⚫
Frequency/Period - Select the period or frequency as the waveform parameter that
can be set.
⚫
Amplitude/high level - Select the amplitude or high level as the waveform
parameter that can be set.
⚫
Offset/Low Level - Select the offset or low level as the waveform parameter that
can be set.
⚫
Pulse width/duty cycle - Select the pulse width or duty cycle as the pulse
parameters that can be set.
HDG3000B User manual
74
or
Output
OFF. The default setting is "Default".
Startup
softkey to select the desired configuration type.
Intensity
softkey and use the direction keys and the knob to change
System Info
softkey to view the information of the device (such as
Units
softkey to select units of waveform parameters.
Copyright © Qingdao Hantek Electronics Co., LTD
EN