Table of Contents
Advertisement
Burst
polarity as "Positive" (or "Negative"). The generator outputs burst waveform only when
the gated signal is "Positive" (or "Negative").
When the gated signal is "True", the generator outputs a continuous waveform; when
the gated signal is "False", the generator completes the current period, and then stops
and holds on the voltage level corresponding to the initial burst phase of the selected
waveform. For Noise waveform, the output will stop immediately once the gated signal
becomes "False".
Gated Burst could only be triggered by External trigger source. In addition, users can
set the "Phase".
10.3
Burst Count
Burst count is the number of carrier waveforms in one burst period. It is only available
for N Cycle Burst mode (internal, external, or manually trigger sources).
For internal trigger source, Burst period ≥ 1μs + Carrier Waveform Period × Burst Count.
Press [Burst] >
and is editable. And use the numeric keypad or direction keys and the knob to input the
desired count. The default is 1 and the settable range is 1 to 2000 000 000.
This menu will be grayed out and disabled when the burst type is set to Infinite cycle or
Gated.
10.4
Burst Period
Burst period is the time from the start of one burst to the start of next burst. It is only
available for N Cycle burst in internal trigger. The default is 10 ms.
⚫
Burst period ≥ 1μs + Carrier Waveform Period × Burst Count.
⚫
If the burst period is set to too small, the generator will increase this period
automatically to allow the output of the specified number of cycles.
Press [Burst] >
Internal, then press
HDG3000B User manual
64
Figure 10.3 Gate Burst
"N
Type
softkey to select
Type
softkey to select
N
Cycle. Press
Period
softkey, and use the numeric keypad or direction keys and
Cycle". The "Count" parameter is highlighted
Trig Src
softkey and select
Copyright © Qingdao Hantek Electronics Co., LTD
EN
Advertisement
Table of Contents
