EN
7.
Press
Edge Time
to highlight it. Use the numeric keypad to enter the value "75", then select the unit
"nsec" from the menu that pops up.
8.
Press
Edge Time
to highlight it. Use the numeric keypad to enter the value "100", then select the unit
"nsec" from the menu that pops up.
9.
Press [Output1] button on the front panel to turn CH1 Output on.
At this point, the specified waveform is output from CH1 based on the current
configuration. Connect the CH1 output terminal to the oscilloscope and the waveform is
as shown in the figure below.
Copyright © Qingdao Hantek Electronics Co., LTD
softkey to enter the edge time submenu. Press
softkey to enter the edge time submenu. Press
Setting Interface
Figure 5.3
Figure 5.4 Output Waveform
Basic Waveform Output
Leading
softkey
Trailing
softkey
HDG3000B User manual
25