Table of Contents
Advertisement
10.3.3 Power On Settings
Set the configuration to be used when the instrument is powered on the next time to Default, Last
or Output off. The default setting is "Default".
Default: Denote the factory default settings except some parameters (such as: Language).
Last: Include all the system parameters and output configuration, except clock source.
Output off: The last setting will be used and all output will be closed.
Press [Utility]>Startup softkey to select the desired configuration type.
When [P] keyis pressed to restore the default settings, this setting will not be affected.
10.3.4 Intensity
Press[Utility] >Intensitysoftkey and use the direction keys and the knob to change the backlight
intensity of the screen.
The ranges from 1% to 100%.
10.3.5 System Information
Press[Utility] >System Informationsoftkey to view the information of the device (such as model,
serial number, version number, etc.).
10.3.6 Unit
Press[Utility] >Unitsoftkey to select units of waveform parameters.
Frequency/Period - Select the period or frequency as the waveform parameter that can be set.
Amplitude/high level - Select the amplitude or high level as the waveform parameter that can be
set.
Offset/Low Level - Select the offset or low level as the waveform parameter that can be set.
Pulse width/duty cycle - Select the pulse width or duty cycle as the pulse parameters that can be
set.
10.3.7 Save Picture
Users can store the content displayed on the screen in an external storage device in the form of
pictures.
First, please connect the USB stick (FAT32 format, storage space is less than or equal to 32G)
and insert the USB stick into the USB port on the front panel of the instrument.After successful
connection, the corresponding prompt message pops up on the screen.
User Manual
73
Advertisement
Table of Contents
