Burst
10
Burst
The HDG3000B can output a waveform for a specified number of cycles, called a burst.
It supports control of burst output by internal, external or manual trigger source;
supports three kinds of burst types including N cycle, Infinite cycle and Gated. Burst is
allowed with sine, square, ramp, pulse, Harmonic, noise (allowed only in gated burst
mode) or arbitrary waveforms (except DC).
10.1
Select Burst
Press [Burst] button on the front panel to enable Burst function (the backlight of the key
goes on), and
enabled).
To avoid multiple waveform changes, enable burst mode after configuring other
parameters.
10.2
Burst Type
This instrument could output three types of bursts, including N Cycle, Infinite Cycle and
Gate. The default is N Cycle.
Burst Type
N Cycle
Infinite
Gated
N Cycle Burst
In N Cycle mode, the generator will output waveform with specified number of cycles
after receiving trigger signal.
Press [Burst] >
HDG3000B User manual
62
Mod
or
Sweep
function will be automatically disabled (if currently
Trigger Source
Internal/External/Manual
External/Manual
Ext
Table 10.1 Table Burst type
"N
Type
softkey to select
Carrier Waveform
Sine/Square/Ramp/Pulse/Harmonic/Arbitr
ary waveform (except DC)
Sine/Square/Ramp/Pulse/Harmonic/Arbitr
ary waveform (except DC)
Sine/Square/Ramp/Pulse/Noise/Harmoni
c/Arbitrary waveform (except DC)
Cycle".
Copyright © Qingdao Hantek Electronics Co., LTD
EN