Figure 10.1 N Cycle Burst; Figure 10.2 Infinite Cycle Burst - Hantek HDG3000B Series User Manual

EN
For N Cycle mode, the trigger source includes "Internal", "External" or "Manual".
Besides, users can set the "Phase", "Count", "Burst Period" (internal trigger), "Trigger
Slope" (external trigger) and "Trigger" (manual trigger).
Infinite Cycle Burst
In Infinite Cycle mode, the cycle number of the waveform is set as an infinite value. The
generator outputs a continuous waveform after receiving trigger signal.
Press [Burst] >
pulse will be displayed on the screen.
For Infinite Cycle mode, the trigger source includes "Internal", "External" or "Manual".
Besides, users can set the "Phase", "Count" and "Trigger Slope" (external trigger) and
"Trigger" (manual trigger).
Gated Burst
In Gated Mode, the generator controls the waveform output according to the external
signal level from the [FSK/Trig/Sync/Extmod] connector on the rear panel.
Press [Burst] >
Copyright © Qingdao Hantek Electronics Co., LTD

Figure 10.1 N Cycle Burst

"Inf
Type softkey to select

Figure 10.2 Infinite Cycle Burst

softkey to select "Gate" and then press
Type
Cycle". A schematic diagram of infinite cycle
Polarity
Burst
to set the gated
HDG3000B User manual
63