Basic Waveform Output
5
Basic Waveform Output
HDG3000B can output basic waveforms (including Sine, Square, Ramp, Pulse and
Noise) from one of the channels separately or from the two channels at the same time.
At start-up, the channel is configured as a sine waveform with 1KHz frequency and
200mVpp amplitude by default. This chapter introduces how to configure the instrument
to output various basic waveforms.
5.1
Select the Channel
Users can configure HDG3000B to output basic waveform from a single channel or from
dual channels at the same time. Please select the desired channel before configuring
waveform parameters. At start-up, CH1 is selected by default.
Press [CH1/2] button on the front panel and the corresponding area in the user interface
is illuminated. At this point, users can configure the waveform and parameters of the
channel selected.
Note: CH1 and CH2 cannot be selected at the same time. Users can first select CH1
and then select CH2 after configuring the waveform and parameters of CH1.
5.2
Set the Parameter
5.2.1
Select the Basic Waveform
HDG3000B can output 5 kinds of basic waveforms, including Sine, Square, Ramp,
Pulse and Noise. At start-up, Sine is selected by default.
Press [Wave] button on the front panel, and then press the corresponding softkey in the
menu to select the waveform and enter the parameter setting menu. Now the user
interface displays the selected waveform shape.
Press [Wave] >
same as the settings of the current channel.
5.2.2
Set the Frequency
Frequency is one of the most important parameters of the basic waveforms. For
different models and different waveforms, the setting ranges of the frequency are
different. For detailed information, please refer to "Frequency Characteristics" in
"Specifications". The default frequency is 1 KHz.
The frequency displayed on the screen is the default value or the frequency previously
set. When the instrument function is changed, if this frequency is valid under the new
function, the instrument will still use this frequency; otherwise, the instrument would
HDG3000B User manual
18
CH1=CH2
softkey to change the settings of another channel to be the
Copyright © Qingdao Hantek Electronics Co., LTD
EN