Compliance; Fcc Compliance Statement; Made For Iphone® And Ipad - DCS Bartok DAC User Manual

Compliance

FCC compliance statement

These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
You can determine whether this equipment is causing interference by turning it off. If the
interference stops, it was probably caused by the equipment or a peripheral device.
If your equipment does cause interference to radio or television reception, try to correct the
interference by one or more of the following measures:
• Turn the television or radio antenna until the interference stops.
• Move the equipment to one side or the other of the television or radio.
• Move the equipment further way from the television or radio.
• Plug the equipment into an outlet that is on a different circuit from the television or radio.
(That is, make certain the equipment and the television or radio are on circuits
controlled by different circuit breakers or fuses.)
(USA only) If necessary, consult dCS Americas LLC or an experienced radio / television
technician for additional suggestions.
Changes or modifications not expressly approved by dCS Americas LLC could void the
manufacturer's warranty.
This product has demonstrated electromagnetic interference compliance under conditions that
included the use of compliant peripheral devices and shielded cables between system
components. In order to maintain compliance with FCC regulations, shielded cables (including
Ethernet network cables) must be used with this equipment. Operation with non-approved
equipment or unshielded cables is likely to result in interference to radio and TV reception.
Responsible party (contact for FCC matters only)
dCS Americas LLC,
PNC Bank Bldg,
300 Delaware Ave, Suite 210,
Wilmington, DE 19801,
USA
Made for iPhone® and iPad®
"Made for iPad" and "Made for iPhone" mean that an electronic accessory has been designed to
connect specifically to iPad or iPhone respectively and has been certified by the developer to
meet Apple performance standards. Apple is not responsible for the operation of this device or
its compliance with safety and regulatory standards.
52
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.