Table of Contents
Advertisement
Board Operation
3
Board Operation
This section describes how to operate the AFE5805EVM for evaluation purposes. Both software and
hardware installation and operation are discussed.
3.1
Software Installation and Operation
The AFE5805EVM USB SPI Ver1 software and AFE5805EVM driver can be dowloaded from the TI
website on the AFE5805
and the setup.exe to install the driver and software, respectively. The personal computer (PC) should
recognize the EVM after software installation.
To launch the software after successful installation, click:
Start Menu → All Programs → Texas Instruments → AFE5805EVM USB SPI → AFE5805EVM USB SPI
Three different modes are shown in
The software updates the AFE5805 registers as soon as users change any current setup (i.e., the
program sends out new register values due to any value change). It is recommended that users change at
least one register value before measurement. Therefore, the register values in a device can be
synchronized to the displayed values on the software interface.
In most cases, users only need to change the VCA setup. The ADC setup can remain the same as the IC
is powered up.
8
AFE5805EVM
product folder
under Tools & software. Run the AFE5805EVM driver install.exe
Figure
5,
Figure 5. AFE5805EVM USB SPI Interface for TGC Mode
Copyright © 2008–2015, Texas Instruments Incorporated
Figure
6, and
Figure
7.
SLOU222C – March 2008 – Revised March 2015
www.ti.com
Submit Documentation Feedback
Advertisement
Table of Contents
