B B A A S S I I C C P P R R O O C C E E D D U U R R E E S - BRP can-am MAVERICK MAX X MR 2023 Operator's Manual

B B A A S S I I C C P P R R O O C C E E D D U U R R E E S S
While reading this Operator's Guide, remember that:
Indicates a potential hazard which, if not avoided, could result
in serious injury or death.
S S t t a a r r t t i i n n g g t t h h e e E E n n g g i i n n e e
Install D.E.S.S. key on D.E.S.S. post.
Press the brake pedal.
N N O O T T E E : :
If shift lever is not set to PARK (P) or
(N) NEUTRAL, the brake pedal must
be pressed to allow engine starting.
Press the engine start button and hold
until the engine starts.
N N O O T T E E : :
Do not press the accelerator pedal. If
the accelerator pedal is pressed at
least 20%, the engine will not start.
Release the engine start button imme-
diately when the engine has started.
N N O O T T I I C C E E
I I f f e e n n g g i i n n e e d d o o e e s s n n o o t t s s t t a a r r t t a a f f t t e e r r a a f f e e w w
s s e e c c o o n n d d s s , , d d o o n n o o t t h h o o l l d d t t h h e e e e n n g g i i n n e e
s s t t a a r r t t b b u u t t t t o o n n m m o o r r e e t t h h a a n n 1 1 0 0 s s e e c c - -
o o n n d d s s . . R R e e f f e e r r t t o o T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
s s e e c c t t i i o o n n . .
Wait approximately 10 seconds to let
engine oil flow through engine and
turbo.
W W a a k k i i n n g g U U p p t t h h e e E E l l e e c c t t r r i i c c a a l l
S S y y s s t t e e m m
Press and release the START button
for less than half a second and the
electrical system will turn ON:
– For 20 seconds, w w i i t t h h o o u u t t powering
any equipment, if the D.E.S.S. key
is N N O O T T installed on the D.E.S.S.
post.
WARNING
– For 10 minutes, powering equip-
ment, if the D.E.S.S. key is in-
stalled on the D.E.S.S. post. The
electrical system will shutdown
after 20 seconds if the D.E.S.S.
key is removed.
W W a a k k i i n n g g u u p p t t h h e e e e l l e e c c t t r r i i c c a a l l s s y y s s t t e e m m
r r e e p p e e a a t t e e d d l l y y o o r r u u s s i i n n g g e e l l e e c c t t r r i i c c a a l l
e e q q u u i i p p m m e e n n t t w w i i l l l l d d i i s s c c h h a a r r g g e e t t h h e e b b a a t t - -
t t e e r r y y a a n n d d y y o o u u m m a a y y n n o o t t b b e e a a b b l l e e t t o o
s s t t a a r r t t t t h h e e e e n n g g i i n n e e . .
O O p p e e r r a a t t i i n n g g t t h h e e S S h h i i f f t t L L e e v v e e r r
Apply brakes and select the desired
shift lever position.
Release brakes.
W W h h e e n n c c h h a a n n g g i i n n g g g g e e a a r r s s e e l l e e c c t t i i o o n n , , a a l l - -
w w a a y y s s c c o o m m p p l l e e t t e e l l y y s s t t o o p p t t h h e e v v e e h h i i c c l l e e
a a n n d d a a p p p p l l y y t t h h e e b b r r a a k k e e s s p p r r i i o o r r t t o o s s h h i i f f t t - -
i i n n g g . . D D a a m m a a g g e e t t o o t t h h e e g g e e a a r r b b o o x x m m a a y y
o o c c c c u u r r . .
C C h h o o o o s s i i n n g g t t h h e e C C o o r r r r e e c c t t R R a a n n g g e e
( ( L L o o w w o o r r H H i i g g h h ) )
It is important to limit situations known
to make the drive belt slip excessively.
The main reason the drive belt will slip
is if the gearbox is in high range when
it should be in low range.
Pay attention to the following:
L L o o w w R R a a n n g g e e
Low range should be used whenever:
– Pulling
– Pushing
N N O O T T I I C C E E
N N O O T T I I C C E E
87